Martin ExteriorWash 200 Series, Руководство пользователя

Страница: 11 / 32

Exterior Wash
TM
200 Series User Manual
11
properties: stainless steel A4-70 grade according to ISO 3506 or steel grade 8.8 according to ISO 898-1).
All nuts used must be self-locking. Washers must be installed between the head of each fastener and the
yoke base.
Referring to the illustration below, use a 12 mm (1/2 inch) shaft diameter bolt in the center hole A. Then
use either two additional 12 mm bolts passing through holes B or two bolts with 8 mm (5/16 inch) shaft
diameter passing through slots C to anchor the fixture. Installing bolts through slots C will give
approximately 90° of pan adjustment. If additional bolts are required to mount the fixture safely, install
bolts through slots C or holes B.
Install washers under all nuts and bolt heads.
Mounting bracket details
Adjusting tilt
Warning! The fixture can become hot. Wear heat-resistant gloves if you adjust the
aim of the fixture when it is (or has recently been) powered on.
Tilt adjustment can be carried out with the fixture powered on as
follows.
1. Put on heat-resistant gloves.
2. Loosen, but do not remove, the tilt lock screws (arrowed) on
both sides.
3. Tilt the fixture to the desired angle and retighten the screws.
Installing a diffuser
Optional diffuser lenses are available to modify the beam width; see table below for details. The label
identifying the nominal diffuser beam angle is partially hidden under the silicone gasket. The diffuser is
held in place either by the included trim ring or, if installed, by the snoot.
Diffuser kit Part number
Nominal
half-peak beam
angle Half-peak
beam angle,
210 model Half-peak beam
angle, 200 &
220 models
None - - 10° 7°
Narrow 91610154 10° 14° 12°
Medium 91610153 20° 22° 21°
Wide 91610152 40° 41° 40°
Very Wide 91610151 60° 61° 60°
Asymmetric 91610150 10° x 60° 14° x 61° 12° x 60°
Exterior Wash
™
200 Series Diffuser Kits