SETTING THE AUTOMATIC FEEDER
For efficient Auto-feeding, the setting of the caliper to the vacuum wheel is very
important. Use a piece of the stock to be run as a “feeler gauge”. Place a sheet under
the feed wheels, turn the feed wheel adjustment screw (Counterclockwise to raise,
clockwise to lower) so that the paper can slip freely under the wheels. The feed wheels
should be barely touching the stock. If during the feeding you begin to get doubles,
lower the feed wheels just enough to stop the double sheeting. The paper between the
friction plate and the auto feed wheel must move freely and should not be gripped.
2
0
HEIGHT ADJUSTMENT CALIPER
The caliper setting is what ensures the feeding of one sheet and prevents the feeding of
double sheets. It is very important that this caliper be set correctly. To set the caliper
take one sheet of the stock you are running and slide it between the caliper and
vacuum wheel. Take a second sheet and slide it back and forth, in and out while
lowering the height adjustment until the second sheet cannot slide under the caliper.
DO NOT OVERTIGHTEN!
It is very important that the sheet is not pinched in anyway.
There are 2 different calipers; the o-ring and the metal caliper. The metal caliper is
designed to work better with heavy stock and the o-ring caliper is designed to work
with lighter stocks. Use the o-ring caliper when running any multi-part forms.
Height Adjustment Knob
Caliper Disk Lock Knob
