SIGNAL
Pin 1 Ground lifted via 470R // 100nF.
Options for pin 1 open circuit, and pin 1
connected directly to electrical earth
INPUT CONNECTION
Captive 1.5M 3-core cable
POWER
OUTPUT CONNECTIONS
3 x Speakon connectors, 1 x 5 pin XLR
(stereo line level sub bass out) this is only
active when a processing module is fitted
(minimum load impedance 1K ohms)
DIMENSIONS
(W) 482mm x (H) 88mm x (D) 384.5mm
(incl. Handles)
(W) 19ins x (H) 3.5ins x (D) 15.1ins
WEIGHT
9.5Kg (20.9lbs)
E1300 PLUG IN PROCESSING MODULES
System specific Martin Audio plug in modules are available for use with the
E1300 to eliminate the use of separate stand-alone controllers*.
To fit the module, first switch "OFF" the amplifier and remove the power
connection to the amplifier.
Unscrew the two retaining bolts that hold the removable panel on to the
front of the amplifier.
Unplug the grey ribbon cable from its 'park' position SK2 on the
motherboard and plug it into the header on the module. If any changes are
required to the function switches they should be done now before the
module is fitted. It is recommended that the high pass filter is switched "IN"
and set for 30Hz when using the module (SW1 and SW2 both pushed IN).
Refit the module into the front of the amplifier ensuring the ribbon cable is
folded under and is not trapped or stretched.
Reinstate the power connection to the amplifier and switch "ON". The green
Card Enable LED on the front panel should now be illuminated. The
selected filtered and equalised signals will now appear on the outputs of the
amplifier, and on the rear 5 way line level out, sub bass connector.
* Refer to E1300 module user guide for detailed set up information.
Martin Audio – E1300 Amplifier
E
NGLISH
23
All material © 2007. Martin Audio Ltd. Subject to change without notice.
