Marshall Electronics VS-7300, Руководство пользователя

Страница: 31 / 47

4. Remote Configuration
User Manual VS-7300 – V1.0 Page 31 of 47 5/2016
DISK
At least 1GB SD memory is recommended. Either EXT3 or FAT32 file system can be
used. A disk with either EXT3 or FAT32 file system can be read in Linux PC.
However, only FAT32 file system can be read in Windows PC.
Less than 4Mbps bitrate is recommended when you record and monitor video
simultaneously since frame dropping may happen due to performance limitation.
Disk Information
Restart the system after connecting an SD card. During rebooting, the system reads
& initializes the status of disk. Once the initialization is finished, the status is shown
on the
Record page of the web-based setup.
Refer to the chart below for Disk Status:
Disk Status Description
Disk Error Detected Error
No Disk Disk is not connected to the system.
Searching Disk
Information Checking for disk status. Refresh the page and wait
until status is changed.
Mounting and
Recovering Disk
Performing recovery process when disk is damaged.
This could take seconds to minutes to recover.
Disk Format Needed Disk is attached but the file type is unknown or
damaged.
Unknown Disk Type
Detected Disk is attached but the file type is unknown or
damaged.
USB Disk Available Available to be used for recording.
Disk removed
or in abnormal state
Disk is detached during operation or damage is
found on the file system. If detected while disk is
connected, formatting the disk is recommended.