Marshall Electronics VS-570-HDSDI, Руководство пользователя

Страница: 17 / 54

VS-570-HDSDI User Manual
2.0 Megapixel Speed Dome Manual
17/54
Connecting Power
1. Carefully check the voltage and current capacity of the rated power. The rated power is indicated in
the back of main unit.
2. After confirming the voltage, connect the power adaptor to the AC power source
then connect the 12V DC connector to the system .

For the DC input models, be careful with the polarity of the DC power. The system will be
permanently damaged if connected to reverse polarity power supplies.

In cases where the power wire is very long, there may be a voltage drop and the system
may not work properly. Make the length of the power wire as short as possible.
Connecting Network
1. Plug thne network cable to Ethernet port (RJ-45 network port).
Connecting Video
1. To display video through the HD-SDI port, connect the port to a monitor using a BNC
coaxial cable rated for HDSDI video.
2. Set Enable Preview option “ON” on the Video tab of web page.
(Please refer to the Video Configuration part of this manual)

When using HD-SDI, video may contain errors if the correct type of BNC coaxial cable is not used.

If the video transmission distance exceeds 100 meters, video data may lost due to a
reduction in the video signal. In order to prevent this use of a repeater is recommended.

When using HD-SDI, video can be only be viewed on a HD-SDI monitor.
Connecting Audio
Audio is full-duplex. It is possible to set the mode as Tx-only, Rx-only or Tx-Rx.
1. Connect the audio input and output ports to the corresponding audio devices.
2. The Audio signal required is line level. Audio equipment using an amp, mixer or other amplifier
should be used.