2.
Installation
User Manual VS-104-3GSDI – V1.0
Page 12 of 67
3/2016
2.6 Check If It Works
Once the power is supplied to the encoder, it will start booting. The system will boot up
to operation mode after approximately 40-60 seconds. The green LED on the Ethernet
Port will flash indicating the system is ready.
Software provided on the disc called
VS Manager
allows you to check the IP address
and other network details of the video encoder. Please refer to the VS Manager
manual for instructions on how to find the IP address of the video encoder and to make
necessary changes.
Encoder LED Display
The LED’s above show that the
Encoder is connected but a Decoder is not.
Once
an Encoder is connected to a Decoder
, the color of the “LINK” LED Display will turn
green and the “DATA” LED will blink as video or audio transmissions occur.
Decoder LED Display
These LED’s above show that the
Decoder has started without connecting to an
Encoder
. Once an Encoder is
connected, the color of “LINK” LED Display will turn
green and the “DATA” LED will blink as video or audio data transmissions occur.
Description of LED
System Status can be monitored with the LED Display:
LED
State
Description
PWR
OFF
Power OFF
Red
Power ON
STATUS
Green Blinking
Normal Operation
Red
System Failure: Needs Diagnostics
LINK
OFF
No Connection to Remote System
Green
Connected to a Remote System
Red Blinking
Decoder Only: Trying to connect to an Encoder
Orange
Illegal Connection (unsupported combination of
system modes)
DATA
Green
Data Transmission in Progress
Red
Data Loss
OFF
No Data Transmission
