Marshall Electronics VS-104-3GSDI, Руководство пользователя

Страница: 11 / 67

2. Installation
User Manual VS-104-3GSDI – V1.0 Page 11 of 67 3/2016
2.1 Connecting Video

Encoder System
Connect a video encoder video output line to the encoder video input port.

Connecting with Megapixel Encoder
Connect a video encoder which supports HDMI or HD-SDI output to the HDMI or
HD-SDI Input port of video encoder accordingly.

Connecting with D1 Resolution Encoder
Connect a video encoder to the video input port of video encoder accordingly.

Decoder System
Connect a monitor to either the HDMI or COMPOSITE (HD-SDI) Output port of
video encoder accordingly.
2.2 Connecting Audio
Audio is Full-Duplex . It is possible to set the mode as Tx-only , Rx-only, or Tx-Rx .

Connect audio input and output ports to audio devices accordingly.

The Audio signal required is line level, so audio equipment with an amp, mixer or
other amplifier should be used.
2.3 Connecting Serial Ports
For encoder control, the PTZ Controller (keyboard) and Receiver can be connected to
Serial Ports. Two corresponding Serial Ports in the Encoder and Decoder which are
connected 1-to-1, works in Pass-Through Mode. This means that commands at a local
system’s COM1 Port will be transparently passed to the remote system’s COM1 Port.
Commands at a local system COM2 Port will pass to the remote system’s COM2 Port.
2.4 Connecting Sensor and Alarm
Connect Sensor and Alarm Devices to corresponding terminals accordingly.
2.5 Connecting Power
After confirming the Power Source, connect Power Adaptor and connect the 12VDC
Connector to the System.