Marshall Electronics Orchid OR-2410, Руководство по эксплуатации

Страница: 32 / 39

Page 32 of 39
REMOTE SUBMENU
■ Pin 1 through Pin 8
The RJ-45 Remote connector on the rear panel
has 8 pins. Pin 5 is Ground, while the remaining 7
pins are pulled high to 3.3VDC and may be used
for Tally or other Remote Commands. A list of
available Commands and Tally configurations can
be found in the
REMOTE section of the Menu
Overview section of this manual. The command or
Tally is activated by connecting the corresponding
Pin (1-4 and 6-8) to Pin 5 (Ground).
Event Triggers
Two types of events are allowed: Falling and Rising Events
The Falling Event is when you pull down to ground, and the rising event is when you
remove the
ground and the pin returns to the normal high state.
Falling Events occur only once and on the event of power up sequence.
o
This means a falling event will occur only once regardless of whether its pin is
repeatedly grounded such as when selecting an input source.
The Rising Event can only occur once a pin has been pulled down to ground to activate
the command such as turning on a tally and then releasing ground (open circuit) to turn
off.
Priority
o
The lower pin numbers have higher priorities over higher pin numbers during the
power up sequence.
Tally System
The Tally System can be used in a non-separated mode and separated mode.
Non-Separated Mode
o
Supports R/G/B tallies.
o
Can mix any channels. FOR EXAMPLE: Mix Red and Green for Amber.
o
Cannot mix R/G/B for White (it will be pink due to white balance).
o
Cannot be assigned with separated tallies.
Left/Right Separated Mode
o
Supports R/G/B tallies on each Left and Right.
o
Can mix any channels for each Left and Right.
o
Cannot mix R/G/B for White (it will be pink due to white balance).
o
Cannot be assigned with non-separated tallies.
SDI STATUS SUBMENU
The SDI submenu shows the SDI Error
Count, allows you to reset the counter
and sets up how you would like to
display the SDI Error counter. The
Choices are OFF – ON – AUTO.
The SDI Error Counter will count the
following types of errors:
• Line-based CRC error
• Line number error
• TRS error
• EDH CRC error
• ANC data checksum error