OWNER’S MANUAL
MODEL VT18 - VERTICAL CONTACT TOASTER
148665 RV032114
2
Copyright
2012 Marshall Air Systems, Inc.
All Rights Reserved.
12. The conveyor speed is preset at the factory for 65 seconds. MM2F models set at 45 seconds.
(Please note that the adjustable speed range is 9 to 105 seconds.)
13. Test at least 3 buns before putting the toaster into service. Uniform surface toasting and bun
temperature are achieved when the gap described in step 10 is set correctly.
14. If necessary, the speed of the conveyor can be changed. The speed control is located behind a
cover on the side of the toaster (see Figure 1 for location). Adjust as needed and reinstall cover.
DAILY OPERATION AND CLEANING GUIDE
1. Press and release the “I/O” Button of the control to turn toaster on. “Lo” will be displayed.
CAUTION: DO NOT OPERATE TOASTER WITHOUT ALL PANELS AND COVERS
INSTALLED.
2.
The display of the control will show “Rdy” once the toaster is up to temperature. (Approximately
15 minutes.)
3. For proper operation, insert heels cut side up on the side of the toaster marked "HEEL", and
crowns on the opposite side.
4. To turn off, press the “I/O” Button “Hi” will be displayed which means toaster is still too hot to
remove any parts. Once the toaster has cooled (approximately 30 minutes), the display will show
“Off.”
5. The LED Control will indicate important information:
A. To see temperature settings, press and release either the Heat 1(Left Platen) or the Heat 2
(Right Platen) Button, the pre-programmed temperature settings will flash. This will display
for 5 seconds or until another button is pressed.
B. To see the actual temperature of heaters, press and hold either the Heat 1(Left Platen) or
the Heat 2 (Right Platen) Button for 3 seconds, the actual platen temperatures will be
displayed. This will display until another button is pressed.
6. Definitions of various displays:
“Off”
Toaster is off and not operating.
“Lo”
Heater platens have not reached programmed set temperature.
“Rdy”
Toaster has reached programmed set temperature and is ready to toast.
“Hi”
Toaster is off and too hot to touch all removable parts.
“AL1”
This is an alarm message that indicates the Left Platen Probe is disconnected or
defective. Toaster automatically shuts off.
“AL2”
This is an alarm message that indicates the Right Platen Probe is disconnected
or defective. Toaster automatically shuts off.
“AL3”
This is an alarm message that indicates the Left Platen is too hot. Toaster
automatically shuts off.
“AL4”
This is an alarm message that indicates the Right Platen is too hot. Toaster
automatically shuts off.