OWNER’S MANUAL
MODEL VT18 - VERTICAL CONTACT TOASTER
148665 RV032114
1
Copyright
2012 Marshall Air Systems, Inc.
All Rights Reserved.
PRE-INSTALLATION
1. The toaster is packaged to prevent the risk of shipping damage. Immediately upon receipt,
inspect the toaster for damage.
FILE ALL CLAIMS WITH THE FREIGHT CARRIER.
2. Unpack toaster and remove all protective paper or plastic from metal parts.
FILE ANY CONCEALED DAMAGE CLAIMS WITH THE FREIGHT CARRIER.
3.
INSPECTION, TESTING AND REPAIR OF ELECTRICAL EQUIPMENT SHOULD BE
PERFORMED BY QUALIFIED SERVICE PERSONNEL. THE TOASTER SHOULD BE
UNPLUGGED WHEN SERVICING, EXCEPT WHEN ELECTRICAL TEST ARE REQUIRED.
4.
It is necessary to check your voltage at the receptacle.
The toaster is factory-shipped set at
208V for domestic and 240V for international service. If voltage at receptacle does not match
rating label, it is necessary to simply change a jumper inside the toaster.
CAUTION: DO NOT REMOVE THE ELECTRICAL CONTROL PANEL COVER ON THE RIGHT
SIDE OF TOASTER WITHOUT FIRST TURNING OFF THE TOASTER AND UNPLUGGING
THE CORD.
Contact the factory for instructions.
INSTALLATION
1. Place toaster on a level surface.
2. Check that all panels and covers are in place on the toaster.
3. Check that the toaster platen sheet is installed over the contact platens. The toaster platen sheet
is installed by placing rods into arms of toaster. See Figure 4 .Make sure seam is against platens
(facing top of toaster).
USE ONLY MARSHALL APPROVED PLATEN SHEETS OR TOASTER
WARRANTY IS VOID.
4. Check conveyor carriage making sure it is completely seated in saddles and on top pins.
5. Connect the toaster to the power supply.
6. Press and release the “I/O” button on the control. “Lo” will be displayed. Check for free movement
of the conveyor belt.
7. Toaster is ready to use in approximately 15 minutes. Control will display “rdy”.
8. After warm up, insert buns into the top of the toaster. For proper operation, insert heels on the
side of the toaster marked "Heel", and crown on the opposite side.
THE CUT SIDES OF THE
HEEL AND CROWN MUST FACE THE TOASTER PLATEN SHEET.
9. The toasted heel and crown will return to the toaster front together. Check the quality of the
toasted buns.
10. Adjust the gap between the conveyor and the toaster heat platens using the two knobs on top of
the toaster (see Figure 1 for knob locations). Both must be lowered at the same time. The knobs
are labeled “HEEL” and “CROWN”. The height gauges in the front indicate whether you are
raising or lowering the platens.
11. The Adjustment Range is .625” – 1.438”.
