
11
Troubleshooting
SYMPTOM
CORRECTIVE ACTION
Display is blank
Install 2 fresh AA Alkaline batteries.
Check wiring connections on thermostat.
No heat
Set system switch to
HEAT
and raise set point above room temperature.
Check thermostat wiring and connections.
No cool
Set system switch to
COOL
and lower set point below room temperature.
If snowflake icon is blinking, allow the 5 minute compressor lock-out to expire.
Check thermostat wiring & connections.
System turns on/off
Adjust the differential setting on the thermostat. A high differential decreases
too frequently or
cycle rate and a low differential increases cycle rate.
not enough
Display is not illuminated
Touch the up or down arrow key. Display will illuminate for 10 seconds.
Room temperature and
Normal (depending on differential setting). Check for drafts that could quickly
set point disagree
change the room temperature before the system is able to correct it.
System fan runs continuously
Set fan switch to AUTO. Check thermostat wiring & connections.
Reduce room temperature or allow a newly installed thermostat to acclimate.
HI indicates a room temperature reading greater than 90 F (32 C).
Increase room temperature or allow a newly installed thermostat to acclimate.
LO indicates a room temperature reading less than 45 F (7 C).
HI is displayed
LO is displayed
70814-IM 12/22/06 2:00 PM Page 11
Содержание 70814
Страница 13: ...13 70814 IM 12 22 06 2 00 PM Page 13...
Страница 14: ...14 70814 IM 12 22 06 2 00 PM Page 14...