Marport Trawl Explorer, Руководство по обслуживанию

Страница: 46 / 94

Trawl Explorer | V5 | System Configuration and Display
Results
You can see incoming data in the control panels, in Sensors Data / Mx .
What to do next
• If you want to apply filters on data received by the sensor, see Configuring the Sensor Settings
on page 46.
• You can now configure the display of incoming data in Scala/Scala2.
Adding the Sensor Manually
You can add the sensor to the receiver from Scala/Scala2, by entering the same settings as the ones
in Mosa2.
Adding the Sensor to the Receiver
About this task
In order to avoid differences of settings between the configuration on Mosa2 and Scala/Scala2,
we recommend you to add the sensor to the receiver with an xml configuration file exported from
Mosa2.
Procedure
1.
From Scala/Scala2, click Menu > Expert Mode and enter the password
copernic
.
2.
Click menu again, then Receivers .
3.
Right-click the IP address of the receiver at the bottom of the page, then click
Configure Receiver .
4. From the left side of the receiver page, click Sensors .
5. From Product Category , select Trawl Explorer .
6. From Product Name , select Narrow Band Trawl Explorer with Target Strength (V1)/(V2)/(V3)
(choose accordingly to Firmware on page 9 installed).
7. From Trawl Gear Location , select the location of the sensor on the trawl. Sensor locations are
called nodes and have a numerical value between 1 and 999. We recommend you to choose: 7, 8
or 9 to install the sensor on the tunnel, and 10, 11, 12 or 13 to install it on the headrope.
| 45