•
Wash away mud or debris with warm water.
•
Use Isopropyl alcohol to clean the end cap and transducer. Use a steel wool
pencil to clean the shoulder bolts, and very fine sandpaper (180 grit) to clean
between them.
Notice:
Do not use highly abrasive materials or jet wash.
Notice:
Special care should be taken with sensors and components
sensitive to mechanical shock or contamination.
Regularly clean the pull cord magnet or it may stop working: remove the metal disk
fixed on the housing and clean the magnet with a swab or Q-tip. See
to know how to remove the components.
Maintenance Checklist
We recommend you to follow this maintenance schedule for better performance and to
avoid any trouble with the equipment.
Before use
•
Check that all attachment equipment are
not worn or torn. Replace when appropri
ate.
•
Check that the sensor is clean. See
for clean
ing procedures.
•
Check the battery level 24 hours before use
and recharge if necessary.
After use
Wash the sensor with fresh water.
Between uses
When the sensor is not in use, store in a dry area,
without humidity, at a temperature between -10°
and 70 °C (14 to 158 °F).
Catch Navigator
| V1 |
Maintenance and Troubleshooting
51
