17. With the recess face plate seated firmly against the
heater section, depress the “thumb pins”. This will
cause the thumb pins to expand and will temporarily
hold the recess face plate in place.
18. Install and securely tighten four screws (supplied) to
secure the recess face plate to the heater section
(Figure 8).
19. Install discharge air grilles. (Refer to “Installation of
Discharge Air Grilles”, page 5.)
INSTALLATION OF DISCHARGE GRILLES
1. Remove the two discharge grilles and two louver guides
from the enclosure carton.
2. Refer to “Adjustable Discharge Grilles Custom Air Flow
Patterns” section of this instruction sheet to determine
desired air flow direction.
3. Place the two discharge grilles onto a flat surface in the
desired configuration with tabs on each end of grilles
upward.
4. Fit the two louver guides over the two discharge grilles
as shown in Figure 9.
5. While holding the assembly together with both hands, fit
one side of assembly into the opening of the enclosure,
and slide this side inward while fitting the opposite side
into the enclosure. (See Figure 10.) Slide the assembly
into position so that the bottom portion of each guide
locks into the opening.
OPERATION
1. Set the thermostat (internal or remote) to highest setting.
This will energize the heating elements and the fan
causing air to flow from the center of the heater.
2. After the operational check, set the thermostat to obtain
the desired comfort level.
NOTE: Heater contains a fan delay on shut down.
-- The fan energizes immediately when the thermostat
turns on the elements.
-- Fan will operate for a short time after the heating ele-
ments are turned off (approx. 1min.)
*
TO WIRE 3Ø: (REFER TO STANDARD WIRING
DIAGRAM)
COMPLETELY REMOVE BLUE JUMPER WIRE
BETWEEN L1 AND L3 ON THE POWER BLOCK.
MAINTENANCE
1. Once each year the heater should be cleaned to remove
dust and foreign material which has collected during the
heating season.
2. Turn off all electrical power at the circuit breaker of fuse
box to disconnect the electrical power to heater.
3. Remove dust and other foreign material with a vacuum
cleaner nozzle or dust cloth.
4. Turn on the main line switch to restore power to the
heater.
Figure 9
Figure 10
Figure 11
Figure 12
WARNING
TO PREVENT THE DISCHARGE GRILLES GUIDES
FROM FALLING, THE GUIDES MUST BE FIT (LOCKED)
IN POSITION AS SHOWN IN FIGURE 11.
!
5
Discharge Grille (2)
Louver Guides
Tabs on
Discharge Grilles
Must Face
Upward
1
1
2
3
Slide grille
assembly into
opening far
enough to clear
louver ends.
Push grille assembly up
into opening.
Slide grille assembly
into position in opening.
Bottom of each louver
guide Must lock in
position in opening.
Louver
Guide
Louver Guide
ELECTRICAL WIRING
Standard
Wiring
Diagram
(Factory
Wired)
Wiring
Conversion
For 3Ø
Installation
* See Note
Below
Wiring
Conversion
To lower
Wattage
(1Ø)
