Turn the ignition switch from the OFF position to the
ON position 3 times leaving it in the ON position the
third time.
Before 15 seconds has passed, push and release the
valet switch 2 times then push the valet switch a third
time and hold it in on until a long chirp is heard then
release it. You are now in transmitter programming
mode.
Step 1
Step 2
Programming the Transmitter
A. The transmitter included with this system have been pre-programmed and should not need re-programming.
B. This system will accept codes from 4 transmitters. If more than 4 transmitters are programmed, the system
will only operate from the 4 most recently programmed transmitters.
C. Use the enclosed information to program additional transmitters
Enter the Programming Mode
3X
2X + 1X (Hold)
Programming the Transmitter
Step 1
Press the “Lock” button on the first
transmitter until you hear a
confirmation chirp/beep. The
transmitter is now coded into the
system.
Step 2
Repeat Step 1 for each additional
transmitter.
Step 3
When finished, either turn off the
ignition key or wait for 15 seconds
to get out of transmitter
programming mode. You will hear 3
long chirp/beeps to indicate you are
out of the transmitter programming
mode.
13
Unlock Driver's Door First Wiring for 3-Wire Positive Door Lock System
87
87A
85
86
30
To +12 Volts
(B)
To Power Door
Lock Switch
Lock/Unlock Wires
Lock
Unlock
87
87A
85
86
30
+ Unlock
Cut
Driver's
Door Motor
White 5-Pin
Mini Connector
Pink Wire
Black 3-Pin
Mini Connector
Green Wire
Blue Wire
Wiring
Harness 5: 3-Pin Mini Black Connector
(continued)
M7A-IM 6/22/06 4:53 PM Page 13
