9
When operating with the Multi-Train System, you can remo-
tely control the loco’s functions. Press the lighting button
(“9” with remotes) to turn the loco lights on or off.
When operating with the Multi-Train System, the loco fea-
tures a “Back-EMF” function. This keeps the motor speed
constant (and under normal conditions the loco speed),
even when the load of the loco changes, for example, in
curves or on grades.
SERVICE
Lubrication
The axle bearings and the side rod ends should be lubrica-
ted occasionally with a small amount of Märklin Oil (7149).
Replacing the light bulbs
Front light:
Pull the lantern housing away from the model.
Remove and replace the bulb (5 volts). Reassemble.
Rear light:
Pull the lantern housing away from the model.
Remove and replace the bulb (5 volts). Reassemble.
Cab light:
Using tweezers, remove and replace the bulb.
Replacing the smoke generator
• Pull the safety cover out of the smoke stack (Fig. 4).
• Use pliers or tweezers to pull the old smoke generator out
of the stack (Fig. 5).
• Cut the wires to the old generator and attach them to the
replacement generator.
• Insulate the connections and push the replacement
generator into the stack (Fig. 6).
• Reassemble.
Replacing the traction tire
• Remove the hex screw on the drive wheel with the trac
-
tion tire.
• Remove the side rods from the wheel.
• Use a small, straight-blade screwdriver to replace the
traction tire:
• Pry the old traction tire out of the wheel groove.
• Gently insert the new traction tire into the wheel groove.
• Make sure that the traction tire is seated properly in the
wheel groove.
