marklin 21410, Руководство пользователя

Страница: 6 / 16

6
Safety Notes
• This model may only be used with the operating system
designed for it.
• Use only switched mode power supply units and transfor -
mers that are designed for your local power system.
• This model may only be supplied with power from a
suitable power generation source.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Not for children under the age of 15.
•
WARNING!
Sharp edges and points required for operation.
Functions
• This model is designed for operation on LGB two-rail DC
systems with conventional LGB DC train controllers or
power packs (DC, 0 - 24 volts).
• This model comes from the factory with a built-in multi-
train system decoder (multi-train system).
• For operation with the Multi-Train System, the model is
programmed to loco address 03.
Note: Use a locomotive controller with more than 1 amp of
train current for this model.
General Notes
• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
Mode of Operation Switch
There is a 3-position mode of operation switch in the loco-
motive (Fig. 1).
Pos. 0 Locomotive stored on the track without power
Pos. 1 Motors and lighting turned on (normal operation)
Pos. 2 Motors and lighting turned on (normal operation)
Programming the Decoder
Numerous functions on the decoder can be programmed
individually. To do this, function values are programmed in
registers (Configuration Variables - CVs). You can program
the function values with the 55015 universal handheld
controller.
• For normal operation, it is not necessary to change the
function values.
• If programming results in unsatisfactory operation,
you can reprogram the factory pre-set values of most
important CVs: Program register CV 55 to function value
55. To reprogram the factory pre-set function values with
the 55015, select programming mode “P” (displays shows
“P --”). Then input 6, 5, and 5 and press the right arrow
button. The display shows “P --” again: Input 5, 5, and 5
and press the right arrow button again.