Market Forge Industries ST-E, Руководство по обслуживанию и запасным частям

Страница: 5 / 21

THE BUZZER
The function of the Buzzer is to signify to the operator that the
cycle of cooking has been terminated
The Buzzer is mounted on a bracket which is positioned at the
front of the unit just under the front removable panel.
HOW THE BUZZER WORKS
The Buzzer electrical circuit is controlled by the timer When
the timer reaches "ZERO" (at the end of the cooking cycle),
the circuit will be completed and the Buzzer will continue to
sound until the timer knob is turned to the "OFF" position
THE COOKER DOOR ASSEMBLY
The door of the Cooker has been engineered to establish a
positive method of sealing the steam pressure within the
cooking cylinder As steam pressure builds up within the
cylinder, the door seal will tend to become more positive
However, the door should be adjusted to make a good initial
seal between the door gasket and the door opening without
the added assistance of internal cylinder steam pressures.
With the simple action of securing the door handle down in a
locked position, the door gasket should be sufficiently
compressed against the door opening, all the way around, to
prevent any steam leakage from occurring.
DOOR ASSEMBLY - Parts List
Item Description Part No.
1 Pivot Spring Bearing .....……….... 10-6765
2 Door Lift Springs (pair) . ..………... 10-2785
3 10 - 32 Machine Screw 1/2" long …10 1776
4 Door Gasket ....... ..………………. . 10-2666
5 Door & Door Spring Assy. .………. 95-3204
6 Door Spring ...... ……………… . 95-0127
— Complete Door Assembly
(Items 1 thru 6) .....………. 95-0124
THE DOOR GASKET
Keep the gasket clean. With normal closing and locking of
the door assembly, a steam-tight seal should be made
between the door gasket and the door opening. This seal
cannot be maintained if particles of foreign matter are
allowed to accumulate upon either of the contacting
surfaces
If leakage should occur by the door gasket before the
additional pressure of a steam build up within the cooking
chamber causes it to stop, the door assembly must be
regarded as improperly adjusted and a readjustment must
be made of the adjustment screw.
To change the door gasket, remove the entire door
assembly as a unit, remove and discard the old gasket,
replace it with a new one (no cement is required), and
reinstall the door assembly. Make an operational check
for leakage and adjust the door if necessary.
5136