2. Installation
(continued)
7. Remove the door interlock assembly by unscrewing the
two nuts that hold it in place (assembly is attached to the
screws in the top right hinge mounting holes,
see fig. 2-1).
8. Remove the four screws in the right side hinge mounting
holes and install them in the left side hinge mounting
holes (where the hinges were originally mounted).
9. Using the nuts removed in step #6, reinstall the door in-
terlock assembly onto the 2 screws in the lower left hinge
mounting holes (see fig. 2-1) by moving the assembly
over the cooking cavity to the other side of the unit.
Rotate the door interlock assembly 180° for installa-
tion, so that the switch is now facing up.
10. Reinstall the top hinge and screws into the right lower
hinge mounting holes. Rotate the hinge 180° for in-
stallation, so that the pin which the door rides on is now
facing up. The hinge must be rotated because it will now
function as the bottom hinge. DO NOT COMPLETELY
TIGHTEN THE HINGE MOUNTING SCREWS YET.
These will be used later for adjusting the door.
11. Remove the door latch assembly from the face of the unit.
The 2 nuts mounting the door latch are located behind
the face of the unit and must be accessed where the right
side panel was removed.
12. Remove the two white hole plugs from the left door latch
mounting holes, and insert them into the right door latch
mounting holes (where the door latch assembly was
originally mounted).
13. Rotate the door latch assembly 180°, and install into
the left door latch mounting holes.
NOTE: Each stud on the latch assembly
should have a plastic washer, a spring, a plastic
washer and a Nyloc type nut,
14. To adjust the tension of the door latch, tighten both nuts
down until the springs are fully compressed, then back
each nut off 1 1/2 turn.
15. Rotate the door 180° for mounting.
16. Slide the remaining hinge into the top door bearing.
17. Slide the door and hinge assembly down onto the hinge
which you have already mounted to the front of the unit.
Use the two screws to mount the top hinge into the right
upper hinge mounting holes. DO NOT COMPLETELY
TIGHTEN THE HINGE MOUNTING SCREWS YET.
18. Slowly push the cooking compartment door closed until
it is latched.
19. The cooking compartment door can now be raised, low-
ered, and/or rotated into position by bumping it with the
palm of your hand or by using a small rubber mallet.
20. First, check the alignment at the front of the door by
making sure that the striker in the door is centered with
the latch mechanism on the front of the unit.
21. Square the door to the unit by raising or lowering the
hinge side of the door, keeping the latch centered with
the striker.
22. Visually inspect the door. Be sure that the door is square
to the unit, the striker is centered with the latch, and the
gasket is in contact with the entire lip of the cooking
compartment.
23. Gently open the cooking compartment door, taking care
not to move it out of position.
24. Tighten all 4 door hinge bracket mounting screws.
25. Close and visually inspect the door again, as described
in step 22.
26. Reinstall the left and right side panels, using the screws
for each panel.
2-2
