Mark-10 ESM301, Руководство пользователя, Страница: 30 / 40

Model ESM301 Programmable Force Test Stand
6.5 PC Mode
The ESM301 can be controlled by a computer via serial communi-
cation. A list of supported ASCII commands is provided below. All
commands must be lowercase.
a Request speed
b Set travel units to inches
c Enter cycle mode
d Move crosshead down
e Set speed (ex. e10.00 = 10.00 in/min)
f Set cycles (ex. f0500 = 500 cycles)
g Set lower travel limit (ex. g05.375 = 5.375 in)
h Set upper travel limit (ex. h10.250 = 10.250 in)
i Set travel units to millimeters
j Set crosshead speed to maximum speed
k Set crosshead speed to minimum speed
l Enter travel limit mode
m Enter manual mode
n Transmit travel and force readings
o Set crosshead speed to programmed speed
p Request stand status*
q Request number of cycles completed
r Request number of cycles set
s Stop crosshead
t Reset cycle counter to zero
u Move crosshead up
v Request upper travel limit
w Request lower travel limit
x Request travel value
z Reset travel to zero
*The transmission of ASCII “p” will return the stand status. The fol-
lowing are the return codes and their definitions:
Crosshead status U = crosshead moving up
D = crosshead moving down
S = crosshead stopped
Operating mode C = cycle mode
L = limit mode
M = manual mode
29