Maritime Geothermal WH-Series, Инструкция по установке и обслуживанию

Страница: 30 / 77

Page 30 002028MAN-01 1-Oct-2015
The following describes each item on the Configuration Tab of the Configuration Page .
IMPORTANT NOTE: System setup is done at the factory. Normally, only the control source, optional alarms and fluid type / fluid mix
may need to be changed. Note that items that become unavailable or are automatic will be greyed out.
Model Configuration: These are used to select the type of heat pump the control board is installed in.
Model Series: Select the model series (refer to nameplate on unit) This will update remaining items to default values.
Model Size: Select the model size (refer to nameplate on unit).
Model Function:
Select the model function (refer to the nameplate on the unit).
Refrigerant Type: Select the refrigerant type (refer to the nameplate on the unit).
Number of Stages: Select the number of stages (refer to the compressor model: ZP = 1 stage, ZPS = 2 stage).
EEV Step Range: Automatically selected.
Jumper Configuration: These are system level settings.
Control Source AIR: Not Applicable.
Control Source HYD: Select desired control source:
BACNet: System is controlled via BACNet MS/TP RS-485 Interface. Refer to the BACNet Interface
Section of the manual for more information.
Signals: System is controlled via hardwired signals from an external source. Refer to the Thermostat
Requirements section of the manual for more information.
Setpoints: System is controlled via on-board aquastat functionality. Refer to the Setpoint Control
section of the manual for more information.
Setpoints Method:
Applicable only if Setpoints selected for Control Source HYD . Select Indoor Loop (default) for the
Indoor Circulator Sampling method or HTS / CTS to use external probes mounted in tanks.
Air/Hydronic Priority: Not Applicable.
Number of Tanks:
Applicable only if Setpoints selected for Control Source HYD and HTS / CTS selected for Setpoints
Method . Select One for single tank systems or Two for systems with a hot and cold tank.
Fan En. For Hydronic:
Not Applicable.
Heat Pump / Chiller:
Not Applicable.
Fluid Selection: Used to select the Indoor and Outdoor fluid types and volume mixture ratios.
Fluid Type (Outdoor): Automatically Selected.
Fluid Mix (Outdoor): Automatically Selected.
Fluid Type (Indoor): Select appropriate fluid type to match the antifreeze type (or water) in the loop.
Fluid Mix (Indoor): Select fluid mixture ratio (by volume). Greyed out if Fluid Type is water.
Pressure Cutouts: Automatically Selected based on Refrigerant Type , Fluid Type and Fluid Mixture .
Alarm Controls: These are optional or automatically selected alarms. If a button is greyed out and the Enabled
Indicator is on the alarm is automatic, if the Enabled Indicator is off then the alarm is not
available. Buttons that are not greyed out are optional alarms.
Outdoor Flow: Not Applicable.
Indoor Flow: Not Applicable.
Phase Monitor1: Optional, for three-phase models only, requires Phase Monitor accessory.
Compressor Status1: Optional, requires current sensor accessory.
Compressor Monitor1: Not Applicable.