Maritime Geothermal WH-Series, Инструкция по установке и обслуживанию

Страница: 29 / 77

1-Oct-2015 Page 29 002028MAN-01
Tools Menu: This is a list of the various tools are used for system setup and monitoring.
Tools—Configuration: This is where the system setup is done. THIS SHOULD BE DONE ONLY BY A QUALIFIED INSTALLER .
Improper settings could cause the system to operate poorly or not at all.
WARNING: Selecting the wrong Fluid Type and/or Fluid mixture can cause the heat exchanger to freeze, possibly rup-
turing it and destroying the heat pump, VOIDING THE WARRANTY. Ensure the Fluid Type and Fluid mixture match
the fluids and mixtures that have actually been put into the system.
The Enabled Indicators
show which alarms are
enabled and which are
disabled .
If an alarm is standard or not availa-
ble the Enable button will be greyed
out. If an alarm is optional (may
require accessory items) the Enable
button will be accessible, click on it
to enable the alarm.
Clicking this will reset the saved
parameters to the default values.
The configuration will need to be
completed afterwards.
Green when pa-
rameters have
been updated, red
during the update.
Firmware Revision can
also be seen on the
LCD Display during
power up.
Model Configura-
tion is used to se-
lect the system
type.
Jumper configuration is
used to select system
options. Items that do not
pertain to the type of sys-
tem selected are greyed
out.
Fluid selection determines the low
pressure cutout value. Select the
appropriate Fluid Type and Fluid
Mixture
by volume .
SEE WARNING ABOVE.
!
Low pressure cutouts are
determined by the combi-
nation of Refrigerant Type,
Fluid Type and Fluid Mix-
ture.
High pressure cutouts are
determined by Refrigerant
type.
Control Source HYD
selects how the system
will be controlled. The
opations are: BACNet:,
Setpoints and Signals.