Maritime Geothermal EMWT-65-HACW-P-1T, Инструкция по установке и обслуживанию

Страница: 22 / 44

Page 22 000662MAN-03 01 MAR 2012
Startup Record Sheet—EMWT-HACW Series Size 25-75 Two-Stage R410a
Installation Site Startup Date Installer
City Company
Province/Country Homeowner Phone# Model
Homeowner Name Serial #
Check boxes unless asked to record data. Circle data units.
Heating and Cool-
ing Zone Loops
All shut-off valve are open (full flow available)
Loop is full and purged of air
Antifreeze type
Antifreeze concentration % Volume % Weight
Loop static pressure PSI kPa
Ground Loop
System All shut-off valve are open (full flow available)
Loop is full and purged of air
Antifreeze type
Antifreeze concentration % Volume % Weight
Loop static pressure PSI kPa
Ground Water Water Valve installed in return line
System
Flow control installed in return line
Domestic Hot All shut-off valves are open
Water
Lines are full and purged
Desuperheater pump wire is disconnected
Electrical High voltage connections are correct and securely fastened
Circuit breaker (or fuse) size and wire gauge for Heat Pump A Ga.
Circulator pump voltages (Outdoor 1, Outdoor 2) V V
V
Low voltage connections are correct and securely fastened
STARTUP DATA
Preparation Voltage across L1 and L2, L1 and L3, L2 and L3 VAC
Green Light is ON
Heating Mode (10
minutes) Suction Pressure / Discharge Pressure psig kPa
Outdoor In (Supply In), Outdoor Out (Supply Out), and Delta T In Out °F °C
Outdoor Flow Igpm USgpm L/s
Compressor L1 (black wire) current A
Heating aquastat setpoint and discharge pressure at cycle end °F °C psig kPa
Domestic Hot Water functioning
Yellow light is ON. Electric element L1 current draw A
Cooling Mode
(10 minutes)
Suction Pressure / Discharge Pressure psig kPa
Outdoor In (Supply In), Outdoor Out (Supply Out), and Delta T In Out °F °C
Cooling aquastat setpoint and suction pressure at cycle end °F °C psig kPa
Final Aquastat
Settings Heating S1 Setpoint, S1 Delta, S2 Setpoint, S2 Delta °F °C
Cooling S1 Setpoint, S1 Delta, S2 Setpoint, S2 Delta °F °C
PRE-START INSPECTION
Date: Installer Signa-
ture: Homeowner Signa-
ture:
A total of three copies are required, one for the homeowner, one for the installer and on to be sent to Maritime Geothermal Ltd.