MARIMEX 10604267, Инструкция по установке

Страница: 64 / 92

64
Technical Data
ProStar 2 m
3
/h
PLUS
ProStar 4 m
3
/h
PLUS
ProStar 6 m
3
/h
PLUS
Voltage 230 V / 50 Hz 230 V / 50 Hz 230 V / 50 Hz
Power input 85 W 190 W 250 W
System flow rate 2 m
3
/h 4 m
3
/h 5 m
3
/h
Protection IP X5 IP X5 IP X5
Delivery 1,5 m 1,5 m 1,5 m
Filter diameter 143 mm 143 mm 143 mm
Effective filtration area 0,036 m
2
0,036 m
2
0,036 m
2
Working pressure 0,2 bar 0,3 bar 0,5 bar
Maximum working
pressure
0,4 bar 0,6 bar 1,0 bar
Maximum water tempe-
rature
35 °C 35 °C 35 °C
Sand medium 10 kg 14 kg 18 kg
Grain size 0,6 – 1,2 mm 0,6 – 1,2 mm 0,6 – 1,2 mm
Protect the environment! Do not dispose of this appliance in municipal
waste. The product contains electrical / electronic components. According to
the European Directive 2012/19 / EU, electrical and electronic equipment
must not be disposed of in municipal waste at the end of its service life, but
must be disposed of in an environmentally friendly places for disposal. You
will receive information about these places at the municipal office
Assembly
Note: Since all joints have seals, it is not necessary to over-tighten the nuts. Plastic
parts could be damaged. The enclosed Teflon tape is used to complete sealing
procedure.
Note:
To assemble, you will need a Phillips or flat-bladed screwdriver, Allen key 10.
1. Installation of the drain fitting in the container
Insert the threaded counterpart through the drain hole of the container from
the inside (FIG. 1.1). Place the seal on the protruding thread and screw on the
socket (FIG. 1.2). Insert a sieve against sand leakage into it. Push the sieve in by
screwing in the plug with the O-ring seal (FIG. 1.3). Manual tightening is suffici-
ent to seal the joints. Using pliers can damage parts.
1. A For a 10L container with a discharge spout, proceed as follows:
Insert the drain sieve through the drain hole of the container from the inside
(FIG. 1.4). Screw the plug with seal (FIG. 1.5) onto the threaded discharge spout.
Manual tightening is sufficient to seal the joints. Using pliers can damage parts.
EN