MAREX 373 Aft Cabin Cruiser
Page
36 of
66
0.1.10 Common errors
Errors, which may stop or block the discharge:
No water into the toilet-
o
Blocked inlet for the water into the toilet (plastic pieces, seaweed
etc.)
o
Filled filter for the toilet pump
o
No power on septic flushing pump
o
Automatic fuse for the septic pump must be reset. Placed in the
fuse panel starboard side. (25 amp) Marked
“TOILET”
The red
light in the panel will be lit if the circuit is broken.
o
No power to the toilet. The fuse has to be reset
Blocked macerator in the toilet bowl
o
Due to a block in the hoses
o
Through use of too much or bad toilet paper.
Tip:
Fill a 1 ½ liters bottle with a strong mix dish wash
detergent and water, place the bottle upside down into
the toilet and squeeze hard to flush the toilet open.
Empty a strong mix dish wash detergent and water,
into the toilet bowl and let the mix work for some time.
Pump in water into the bowl and try to flush
Demount the engine in the Macerator. Remove the
plastic cover, unscrew the four screws and clean.
Caution: Make sure to place the rubber SIMRING in
correct place. The toilet will leak if otherwise.
.
Blocked air ventilators can prevent emptying the toilet and tank and can
cause bad smell.
Tip:
Flush with water into the ventilators from the outside
of the boat and into the ventilators. The septic can
have dried and become ”composted”
Tip:
Fill the septic tank with freshwater and sanitary liquid
through the septic tank outlet in the deck ( the fitting)
Discharge through hull fitting /valve is not working correctly (macerator
pump in engine room)
o
No power on the macerator pump 25 amp) Marked
”12 V CABIN”
The red light will then turned on.
o
Macerator pump blocked by not dissolved paper or not dissolved
septic.
