MAREDO VibeSpike GT 210 061, Руководство пользователя

Страница: 4 / 8

4
REMARKS
1.Do not use the spiker unit in very wet conditions.
2. Clean the unit regularly with air or low pressure water. DO NOT USE
HIGH PRESSURIZED WATER.
3. If the centre hydraulic motors do hit each other (TORO), you can place
the front units a little offset.
4. Play with the engine throttle and the driving speed, if the holes do not
look nice. Too much vibration in weak turf may cause damages. Reduce
engine revs or increase forward speed.
5. You may use the heads without drive. For that it is the best you
remove the hydraulic motors from the heads.
6. Be careful when dropping the units on a hard (concrete) floor. PUT
SOMETHING UNDERNEATH TO PROTECT THE SPIKES, PLATES OR
ROLLERS.
7. Check bolts and nuts regularly.
8. START AND STOP PROCEDURE: Set the engine throttle at appr. 75%.
Drop the units and move forwards. Increase throttle if necessary (
otherwise stay at 75%). At the end of the pass, reduce engine rpm till 75%
and raise the units. NOTE: Because the spikes start spinning when dropping
the heads, they may hurt the turf. Start with lower rev’s, outside the green
or engage the drive of the heads when the spikes are in contact with the
soil (if possible).
9. You can make curves with the units during work, BUT DO NOT MAKE
TIGHT CURVES. Damage to the units and green may appear.
10.
CHECK THE (HYDRAULIC) DRIVE OF THE GREENSMOWER
REGULARLY. DO NOT OVERLOAD THE GREENMOWER. MAREDO IS
NOT RESPONSIBLE FOR DAMAGES TO THE GREENSMOWER
.
11.
As an option, a trolley is available, that can be easily connected to each
head. Next you can easily roll the head in and out the greensmower.
12. You can set the depth by changing the front roller position. Set both
side at the same position.
13. As options, we have more different types of spike tools available, that
fit on the main sections. Either thinner spikes or even continuous disks. The
vibration help them doing the work, like with the standard spikes.