- -
5
3.7 Holding the weight (KEY=3)
Press MOD Key to enter the hold function. After every weighing, the weight value will be kept on the display.
MOD Key can be pressed to cancel hold function.
3.8 Presetting tare value (KEY=4)
Press MOD Key to preset tare value. While every weighing, the value displayed is the one actual weight
substrate the preset tare value.
3.9 Animal weighing (Key=5)
Press MOD Key to set parameters of animal weighing.
1) Stable time
“Fil n”. Options: 1/2/3/4/5. 1 is the fastest and 5 is lowest. The longer of stable time, the harder to
lock.
2) Display range
“Rang n”. Options: 1/2/3. Option 2 is recommended.
3) Leaving lock range. If the change of weight exceeds the value, the indicator will get a new display.
Press FUN Key to enter or cancel the animal weighing function.
3.10 Check-Weighing
Check-weighing is a procedure to cause alarm to sound when the weight on the scale meets or exceeds values
stored in memory. The memory holds values for a high limit and a low limit.
Check range:
Set hi-limit and low-limit as different values, and hi-limit value is larger than low-limit value.
Check key point:
Set hi-limit and low-limit as same value.
Check mode:
Setting the parameter: Select
”F4 CHK” to enter check mode. Press FUN Key to enter and sub select “BEEP 1,
BEEP 2 or B
EEP 3”; Press FUN Key, it will show “XXXXXX”. Then begin to set high-limit value; Press Enter to
set low-limit value;
Mode 1: BEEP=1, never beep whether it is eligible or not, but the indicator HI or LO will be on or off to show the
result. When the weight is higher than the high-limit, indicator HI will be on, while lower than the
low-limit indicator LO will be on. Otherwise indicator HI & LO will be both on.
Mode 2: BEEP=2, beep when it is eligible;
Mode 3: BEEP=3, beep when it is not eligible.
Note: The weight must be greater than 9 scale divisions for the check weighing to operate. To disable the
check-weighing function press UNIT Key to set both high and low limit to zero.
