Versa Electronics
www.MarCumtech.com
- 3 -
To charge the , power the system off (5 second hold of power
button) and locate the rubber cap on the back of the monitor just to the right
of the cable storage reel. Lift the rubber cap to expose the USB Charging
port. Insert the supplied USB cable and connect it with the supplied
charger, or any USB port. Once the charger is connected to either the wall
outlet or USB port, the charge indicator light (on rear of unit next to A/V
Port) will illuminate – red indicates that the system is charging, green
indicates the system is fully charged. When using the wall outlet there is a
light on the charger that will always be green when plugged in. This light
will indicate there is power being supplied. To verify if the system is
charged, please check the charge indicator light on the rear of the unit.
Once charging is complete, unplug the charger, remove the USB charging
cable from the system, and properly seal the rubber cap. Best practice is to
charge after every use regardless of how far down the battery was
discharged. This will ensure the longest run-time each time the system hits
the water.
OPERATION
The Control panel located on the front right side of system features four
buttons, with one on the left side.
Power Button
The bottom button powers the system on and off. Press the power button to
turn the system on. A start up screen with the MarCum logo will briefly
show, followed by the video image. To turn the system off press and hold
the power button for 5 seconds until the system shuts down.
LED/Up Arrow Button
The LED/Up arrow button serves a dual purpose. When selected it will turn
on and increase the intensity of the LED lights. An on-screen display will be
shown momentarily to indicate the light intensity level selected. There are
three intensity levels and an off selection.
When in the menu section of the system, this button serves as an up
selection.
IR/Down Arrow Button
The IR/Down arrow button serves a dual purpose. When selected it will turn
on and increase the intensity of the Infrared lights. An on-screen display will
be shown momentarily to indicate the light intensity level selected. There
are three intensity levels and an off selection.
When in the menu section of the system, this button serves as a down
selection.
Menu/Enter Button
The Menu/Enter button serves a dual purpose. Pressing once accesses
the Menu system.
Once inside the menu system it functions as the enter
button.
Record Button
The Record button serves a dual purpose to both take a picture and record
video. (see “Built-In DVR”)
