Marco 1000201, Инструкция по эксплуатации

Страница: 8 / 28

8
3. Basic Installation
3.1 UNPACKING INSTRUCTIONS
•The chiller must be handled only in a vertical position. Transporting the appliance in a horizontal position can cause severe damage
to the refrigerator.
• If the chiller arrives in a horizontal position, leave to sit for 3-4 hours in the verticle position before turning the chiller on.
•Remove the exterior and interior packing. Packing materials (especially any plastic bags) should be stored out of the reach
of children, as a potential source of danger. When disposing packaging parts, please follow current regulations on the matter,
separating carton from plastic parts.
•Always check that the chiller that is delivered corresponds to the model indicated in the accompanying document.
•The chiller is shipped in a cardboard box. Once the packaging has been removed, check the chiller has not been damaged in transit;
if damage is found, notify the carrier.
3.2 ELECTRICAL INSTALLATION PROCEDURE
When installing the chiller, always observe the local regulations and standards. The chiller is supplied with a moulded power cord.
A suitable mains power supply socket should be available within easy access of the chiller so that it can be disconnected easily
after install.
3.3 PLUMBING INSTALLATION PROCEDURE
• Ensure that the chiller is installed according to local plumbing & water regulations.
• Fit a stop valve on a cold water line and attach a 3/8” BSP male fitting, (E.g. 3/4” x 1/2” 311 or washing machine type stop valve).
• Connect water supply lines following the installation drawings. As per installation guide (starting page 14).
• Push the pipe firmly into the fittings until locked into position to avoid leaks. 15mm is the correct depth of insertion.
• In case filter systems are used verify that they satisfy the requirements of the legislation in force.
• The chiller has a pressure reducer in case the incoming water exceeds 3 bar.
• Turn on the water to flush any impurities, dust etc from the inlet hose and water pipe. Allow several litres through. Especially for
new installations.
Tube 3/8” diameter