1900064
REV.3
Page 5 of 8
A brew should only be selected whenever the green ‘Ready to brew’ lights are
illuminated in order to produce the highest quality of coffee possible. (the brew light
turns on when there is enough water at the correct brewing temperature. If there is
enough water yet it is not at optimum temperature, it is possible to brew but the brew
light will not be illuminated)
Left and right brews can run simultaneously (although the two brew buttons should not
be depressed at exactly the same time. Press and release one brew button before doing
the same on the other side).
HOT WATER:
When the machine is full, up to 17.5 pints/10 litres of water is available for tea etc. If all
this water is used and no water is available at the hot water tap, the machine should be
left for a short while to recover (Heat-fill mode).
Using hot water at a faster rate than the machine can recover will result in a temperature
drop in the beverage (Continuous fill mode).
Note: A brew can still be selected after all the hot water has been drawn off the hot
water tap. While the machine is brewing, however, the hot water recovery rate is
reduced and the machine will take longer to replenish the hot water supply.
LOCK FUNCTION:
The Qwikbrew 2 Twin has a button lock function to prevent untrained personnel
operating the machine, or accidental misuse by trained personnel. If the lock button (left
hand side control panel) is pressed for approximately 6 seconds, a red light next to the
button will illuminate. Both control panels are now ‘locked’. No buttons are operational
when the lock function is enabled. The machine will operate as normal, i.e. if the
machine is brewing, it will continue to brew. Once completed another brew cannot be
selected until the lock is disabled.
Note: The ‘Ready to Brew’ lights will still be on, but no brew will be able to be selected.
To disable the lock function – hold the lock button for approximately 6 seconds once
again.
