14
Step 1: Connect CONTROL wires
START
Connect the
Battery
Temperature Sensor
to the
terminal of the middle battery,
Plug the connector on the other
end into the
TRTC.
Connect the
External
Cabinet Fan
and the
RS232/
USB Computer Cable
(if used).
Connect the programmable
contacts:
ON BATT, LOW BATT,
TIMER
or
SELF TEST
contacts
from TRTC to traffic cabinet for
Flash mode (if used).
Figure 5
TRTC Front Panel
GO TO STEP 2
Step 2: Connect ATS to the TRTC
START
Connect the cord from UPS
OUT at ATS to the
AC OUT
receptacle on TRTC.
Connect the cord from UPS
IN on ATS to
AC IN
receptacle on TRTC.
Connect the cord from
Bypass control
on ATS
to
PTS
on TRTC.
GO TO STEP 3
TRTC Front & Power Transfer Switch
TIP: Torque status/self-test terminal
block to a maximum of 4.4 lb in (0.5
Nm). Maximum wire size is 14 AWG.
TIP: (See Section 2.1.2, Fig. 16) of
this manual for details on the layout,
operation, and specifications of the
Control Terminal Block.