The Outlaws’ Guide to the Marantz SR5004
Marantz SR5004
44
_
default value is “Main.” If you wish to hear the Sub channel when it is available, set
“Audio” to “Sub.”
“HDMI Audio” should be set to “Enable” in most cases. This setting allows the SR5004
to play the audio delivered via HDMI. The “Through” setting will pass the incoming
HDMI audio signal through to the TV, but will not allow the SR5004 to use the audio. If
“Through” is selected, all inputs using an HDMI video connection will require a separate
audio connection.
If the SR5004 is connected to an HDMI v1.3a display, “HDMI Lip-Sync” can be set to
“Enable” to allow the SR5004 to automatically determine the audio delay required to
compensate for delays in the video signal caused by video processing.
Acoustic EQ
The
Acoustic EQ
menu provides control over both Audyssey-calculated and manually-
adjusted EQ curves as well as two Audyssey features. The menu is described in the
SR5004 User Manual (see page references below) as well as here in the Roadmap to
the Setup Menus.
Acoustic EQ Menu
EQ. Mode:
Page 38
Adjust User EQ:
Pages 38-39
Check Audyssey MultEQ:
Pages 38-39
Audyssey Dynamic EQ:
Page 38
Audyssey Dynamic EQ Adj.:
Page 38
Audyssey Dynamic Volume:
Page 38
