Mantis 7263, Руководство пользователя

Страница: 19 / 68

19
Troubleshooting
Problem Cause Remedy
1. Tines don’t turn when throttle – Engine is not seated properly on the gear housing. – Re-install engine following the instructions
is depressed
2. Engine fails to start – “
o/
i
” switch is in “
o
” position. – Move switch to “
i
”.
– No fuel in tank. – Fill Tank.
– Fuel filter clogged. – Replace filter.
– Fuel line clogged. – Clean fuel line.
– Spark plug shorted or fouled. – Install new spark plug.
– Spark plug is broken – Replace spark plug.
(cracked porcelain or electrodes broken)
– Ignition lead wire shorted, – Replace lead wire or attach to spark plug.
broken or disconnected from spark plug.
– Ignition inoperative – Contact your Mantis Service Department.
– Diaphragm clogged – Replace diaphragm
3. Engine hard to start – Water in petrol. – Drain entire system and refill with fresh fuel.
– Engine under or over choked. – If flooded by over choking, proceed according to
instructions in operation section. If under choked,
move choke lever to closed position and crank two
or three times.
– Gasket leaks (carburettor or cylinder base gasket). – Replace gaskets.
– Weak spark at spark plug. – Contact your Mantis Service Department.
4. Engine misses – Dirt in fuel line or carburettor. – Remove and clean.
– Spark plug fouled, broken or incorrect gap setting. – Clean or replace spark plug – set gap to
(.024-.028 in.) 0.6-0.7 mm
– Weak or intermittent spark at spark plug. – Contact your Mantis Service Dept.
5. Engine lacks power – Air filter clogged. – Clean or replace air filter.
– Muffler clogged. – Clean carbon from muffler.
– Spark Arrestor Clogged. – Clean Spark Arrestor
– Poor compression. – Contact your Mantis Service Department.
6. Engine overheats – Air flow obstructed – Clean flywheel cylinder fins and screen.
7. Engine noisy or knocking – Spark plug in incorrect heat range. – Replace with plugs specified for engine.
– Bearings, piston ring or cylinder walls are worn. – Contact your Mantis Service Department.
8. Engine stalls under load – Engine overheats. – Remove dust and dirt from between fins