21
Section 6
CLEANING
6.1
GENERAL REMARK (Ref. Pic. 5-6-7-8)
WARNING!
Before carrying out any cleaning or maintenance operation it is important:
- Disconnect the plug in order to isolate the machine from the mains.
- Return the gauge plate knob (4) at the stroke end clockwise.
- Move the food carriage to its stroke end facing the operator, unscrew the knob or lever locking the
carriage and remove it.
- Wear acts to perform this operation: safety shoes, safety gloves for cleaning operation close to the
sharp parts and also during the removal of all parts of slicer, headphones (to keep the hair), gowns
with cuffs attached. Remove necklaces, bracelets, scarves, ties, scarves and / or any garment or
accessory that could become caught in moving or protruding parts of the slicer
The machine should be cleaned at least once a day and, if necessary, even more frequently, i.e. when the
product to be sliced is changed.
We recommend that the machine operator should receive some instructions from the Manconi authorised
TAS during the installation phase of the slicer.
The model is made in the IPX3 version, which means that it is permissible to wash the external parts with a
rain of jet water. While the slicer is constructed of rust-proof materials and some parts are fitted with guards
and seals, do not wash the sharpener and the electromechanical parts beneath the main frame.
All parts of the machine that come in direct or indirect contact with the products to be sliced must be cleaned
very thoroughly in conformity to the national laws.
Use only water and neutral detersive/disinfectant (PH 7– 8) for degreasing, clean water for rising and
soft clothes for drying. Use temperatures no higher than 45°.
6.2
DISASSEMBLY (Ref. Pic. 5-6-7-16-17-18)
Pic. 16–Plate VX VE SMARTY
Pic.17–Plate VX BV SMARTY Pic.18–Plate VX BVC SMARTY
To facilitate and optimize the cleaning was planned dismantling of the details listed later in this chapter. For
these operations also is not needed any tools or tool.
Removing the food carriage (only for VX BVC SMARTY, VX BV SMARTY, VX VE SMARTY)
- Turn the knob (4) at the end stroke clockwise and move the carriage support to the end of its stroke,
operator side.
- Turn the locking lever (7) (ref. pic. 5-6-7) until its end stroke and following the arrow direction
- Remove the food carriage (19), pulling it upward and taking care not to move the carriage support from its
end position, operator side.
This is the only position where the carriage can be removed. If you try to remove the carriage in other
positions along its stroke, some parts very important for the mechanical safety will be uselessly
stressed.