14
Part Number: 040006019 Rev. 01 09/18
ELECTRICAL CORD STRAI RELIEF
To prevent strain at the electrical connection inside the
ice machine, an electrical cord strain relief device must be
installed on the rear panel of the ice machine.
1. Disassemble the strain relief device into its three
components.
2. Install the cord holder through the opening in the lower
right corner of the rear panel of the ice machine.
COMPRESSIO
UT
ELECTRICAL
CORD
CORD
HOLDER
RETAIIG UT
(BEHID THE
PAEL)
Strain Relief Installation
3. Hand-tighten the retaining nut onto the cord holder
from inside the ice machine rear panel.
4. Slide the compression nut over the electrical cord.
5. Feed about 5 ft. (1.5 m) of electrical cord through the
cord holder. (The extra cord will allow the rear panel to
be removed for future service.)
6. Hand-tighten the compression nut onto the cord holder.
TERMIAL BLOCK WIRE COECTIO
n
Warning
Always disconnect power to the ice machine before
working on electrical circuitry.
After the electrical cord is installed in the strain relief device,
the cord must be connected to the terminal block to supply
power to the ice machine.
1. Remove two Phillips head screws to remove the lower
panel from the front of the ice machine.
2. Carefully reach into the ice machine and pull the
electrical cord forward to the terminal block.
3. Strip away enough insulation from the electrical cord
to allow for good electrical connections at the terminal
block.
TERMIAL
BLOCK
ELECTRICAL
CORD
L1
GD
Terminal Block Connections
4. Open the screw terminals on the terminal block.
5. Connect each wire in the electrical cord to the
appropriate screw terminal.
6. Carefully tighten the screws over the wire.
7. Tug lightly on each wire to be sure the connections are
secure.