Manitou MT10044XT, Руководство оператора и сервисное руководство

Страница: 34 / 114

50960025/CP0514
30
PRINTED IN U.S.A.
Two-Joystick Configuation
Frame Level/Attachment Tilt Joystick: The machine
may be tilted slowly as much as 10° to the left or right
to level the frame and boom in relation to the ground.
Move the joystick handle to the left to tilt to the left;
move the joystick handle to the right to tilt to the right.
To tilt the attachment tool up, move the joystick handle
rearward. To tilt the attachment tool down, move the
joystick handle forward.
After the attachment tool is set to a desired angle, that
angle will be maintained as the boom is raised and low-
ered, extended and retracted, until a new angle is set.
Boom Control Joystick:
This machine has a
hydraulic-type boom with telescopic sections. The sec-
tions extend by means of a hydraulic cylinder and a
chain system inside the boom, sequenced for uniform
extension of each section.
To extend the boom, move the joystick handle to the
right; to retract the boom, move the joystick handle to
the left. To raise the boom, move the joystick handle
rearward; to lower the boom, move the joystick handle
forward.
Outrigger Switches:
The outriggers are used to pro-
vide greater stability in specific applications. Press the
left switch forward to lower the left outrigger. Press the
right switch forward to lower the right outrigger. Press
both switched rearward to raise the outriggers.
Level the frame before lowering the outriggers. Lower
the outriggers until the front tires just start to raise.
WARNING
DO NOT level the frame with the boom raised
or extended. Only level the frame while
stopped and with the boom fully retracted and
the attachment raised just enough to clear the
ground.
Frame Level and
Attachment Joystick
Boom Control
Joystick
Auxilliary
Hydraulics
Control
Outrigger
Switches
Two-Joystick Configuration
WARNING
Use extreme caution when raising or extend-
ing the boom. The Telescopic Handler MUST
be level. Loaded or empty, this machine can
tip if not level.
ALWAYS place the transmission in neutral, set
the parking brake and keep the service brakes
fully applied before raising or extending the
boom.
NEVER exceed the specified lifting and
extending capacities of this machine, or seri-
ous machine damage or personal injury may
result. Refer to the load charts at the opera-
tor’s station or this manual.
If a boom circuit hose fails with the boom up,
with or without a load, shut down the machine
following the MANDATORY SAFETY SHUT-
DOWN PROCEDURE (page 9). DO NOT
attempt repairs. Call your Manitou Americas
dealer for assistance.
The truss boom and winch attachment tools
should ONLY be used to lift and place loads
when the machine is in a stationary position.
Transporting suspended loads must ALWAYS
be done slowly and cautiously, with the boom
and load as low as possible. Use taglines to
restrict loads from swinging, to avoid over-
turn.
NEVER use winch for lifting or moving of per-
sonnel. NEVER exceed the maximum rated
capacity of the winch (3000 lbs./1360 kg) or
exceed the load chart rating for winch appli-
cations.
DO NOT tilt the truss boom back more than
45° from horizontal. DO NOT attempt to use
the optional rotating carriage as a load level-
ing function. ALWAYS level the frame prior to
raising a load.
ProCarManuals.com