Manitou MHT 10180 LT-E3, Руководство оператора

Страница: 61 / 223

2-29
C - “SUSPENDED LOAD” MODE
Use with crane jib (P, PC, PT, PO).
-
Place the lift truck in the transport position.
- Press the button for 2 seconds, “SUSPENDED LOAD” MODE is validated by an audible beep
and the lighting of the lamp.
- Return to “HANDLING” MODE by pressing the button .
A1 - A2 - A3: There is a significant reserve of longitudinal stability.
A4 - A5: The lift truck is approaching the limit of longitudinal stability, move with care.
A6: The lift truck is very near at the limit of longitudinal stability. The alarm sounds simultaneously
with a slow intermittent sound. Move with care.
A7: The lift truck is very near at the limit of longitudinal stability. The alarm sounds simultaneously
with a fast intermittent sound. Move with extreme care.
A8: The lift truck is at the authorized limit of longitudinal stability. A continuous acoustic alarm
is simultaneously sounded. All “AGGRAVATING” hydraulic movements are cut-off. Cut-off may be preceded by automatic
slowing of hydraulic movements. Only perform hydraulic movements that increase stability in the following order; retract and
raise the jib.
NOTE: When the jib is retracted, the function for cutting-off “AGGRAVATING” hydraulic movements is disconnected.
D - KEY SELECTOR FOR DISCONNECTING THE LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE
In certain cases, in order to get out of a difficult situation, the operator can bypass this safety system.
Key selector D temporarily disables the cutting-off of “AGGRAVATING” hydraulic movements.
-Keep key selector D turned in position “0” to proceed and simultaneously perform the necessary
”AGGRAVATING” hydraulic movement with extreme care. The combined use of these two actions is
limited to 60 seconds.
Remain very vigilant during this operation. The only information available to the operator is the lift truck’s
dynamic stability.
The safety system can be deactivated manually only in case of emergency and for reasons of safety
With the safety system deactivated, the operator and the truck are exposed to risks and there is nothing to prevent
overloading and/or tipping over of the vehicle.
Key selector D has two positions “1” and “0”:
- in position “1” the safety system is activated;
- in position “0” the safety system is deactivated.
During normal use, the key selector is turned to position “1”, the safety system is activated.
Key D is kept safe inside a safety box D2 placed behind the driver’s seat.
Break the safety glass to pick up the key D3.
Note: When the safety system is disenabled, an a warning light (ARB) D4 and allarm sound is
automatically activated to warn the driver and other persons who may be present in the area
of a possible danger situation.
When the emergency procedures have been completed the key must put back in the safety box and the safety
glass must be replaced.
.
A8
A7
A6
A5
A4
A3
A2
A1
D
D2
D1
D3
D4