Manitou 200 ATJ, Руководство оператора

Страница: 108 / 138

3 - 18
D - EVERY 500 HOURS OF OPERATION
D1 - I.C.
ENGINE OIL
EMPTY - REPLACE
D2 - I.C.
ENGINE OIL FILTER
REMPLACER
- Set the platform on a horizontal surface and let the engine run for a few
minutes, then stop it.
DRAINING THE OIL
- Open the left-hand cover.
- Place a receptacle on the ground.
- Loosen the drain plug 1 (Fig. D1/1).
- Remove the filling plug 2 (Fig. D1/2) to ensure good drainage.
- When drainage is complete, re-tighten the drain plug.
Dispose of the oil an environmentally friendly manner.
REPLACING THE FILTER
- Open the steerable engine support.
- Remove the engine's oil filter 3 (Fig. D1/3) and dispose of it, together with its
seal.
- Clean the filter support with a clean, non-fluffy cloth
- Lightly oil the new seal
- Refit the oil filter in its support.
- Close the steerable engine support.
Only tighten the oil filter by hand and then use the filter spanner
to lock it with a quarter turn.
FILLING WITH OIL
- Ensure that the drain plug 1 (Fig. D1/1) is in place and tight.
- Fill full of oil (see the LUBRICANTS section) through the filling hole 4 (Fig.
D1/2).
- Wait a few minutes to allow the oil to flow into the casing.
- Check the level with the gauge 5 (Fig. D1/4).
- Start the engine and let it run for a few minutes.
- Check for any leaks around the drain plug and the engine oil filter.
- Stop the engine, wait a few minutes and then check the level is between the
two upper marks on the gauge 5 (Fig. D1/4).
- Fine tune the oil level if necessary.
Perform the operations described previously as well as the following operations
D1/1
1
D1/2
4
2
D1/3
3
D1/4
5