Manitou 160 ATJ E3, Инструкция по эксплуатации

Страница: 103 / 160

2-57
15
L
OADING
/
UNLOADING THE LIFTING PLATFORM
Check that the safety instructions relating to the truck bed have
been correctly applied before loading the lifting platform and
ensure that the transport vehicle’s driver is aware of the lifting
platform’s dimensional characteristics and its weight (see the
CHARACTERISTICS section).
-
When loading the lifting platform on to a truck bed, the platform must be in Transport
position:
• Counterweight facing the ramp (counterweight above the lifting platform’s
steering wheels) (see 1 – Safety instructions and advice in the SAFETY
STICKERS section, Ref Nos. 1 and 2).
•
Upper arm on its stop
•
Lower and intermediate arm in the Low position
•
Telescope retracted
•
It is possible to raise the pendular arm so that it does not touch the ground
but it is inadvisable to make a translation movement with the basket
raised excessively; keep the basket in the lowest possible position during
manoeuvres (danger of objects falling or impacts; see 1 - Safety Instructions
and Advice; Driving Instructions section).
•
Block the lifting platform’s turret from rotating by using the pin 1 (Fig. A
(see the CONTROL INSTRUMENTS section, paragraph: BLOCKING TURRET
ROTATION)
•
Use “Ramp” speed
Ensure that the truck bed is large enough and has a sufficient load
capacity to transport the lifting platform. Also check the truck bed’s
permissible ground contact pressure with regard to the lifting
platform.
There is a risk of the lifting platform losing adherence (sliding or
slipping) when going up or down the loading ramps, when these
are wet, muddy or damp. It is therefore necessary to ensure the
platform’s stability with a winch attached to the lash-down points
on the machine.
L
OADING
-
Fix the loading ramps to the truck bed so as to have the smallest angle possible for
loading the machine (Fig. B).
-
Chock the truck bed’s wheels 1 (Fig. C).
Please adapt the lifting platform’s translation speed by controlling
it with the translation joystick.
P
ROCEDURE FOR FOLDING THE LIFTING PLATFORM
- Rotate the basket to the left on its stop.
-
Raise the upper arm.
-
Initiate the basket tilt movement to fold the basket under the upper arm.
-
Lower the upper arm, paying attention not to hit the basket on the ground.
- Initiate the basket tilt movement again to fold the basket to the maximum under the
upper arm (Fig. C).
B
A
C
1
647414 EN (27/05/2015)