BREWING.
OUR OBSESSION.
9. FITTING AND CONNECTING YOUR KEGS
• Attach a grey gas disconnect to the “IN” side of one of the Kegs.
NOTE:
To attach and detach you should push the centre of the disconnects down with your thumbs
while pulling the bottom up with your fore-fingers.
• Attach a black liquid disconnect to the “OUT” side of the same Keg.
• Repeat for second Keg (and third keg if you have a third tap) with remaining disconnects.
• Place Kegs inside the Kegerator ensuring that the tubing sits at the back and is not tangled.
• Place Kegerator where it has at least 30 cm (11.8”) clearance on either side and from the back
of the unit to the wall, to allow proper ventilation.
• Place drip tray on top of the Kegerator, turn it on and your Kegerator is set up.
