WWW.MANGROVEJACKS.COM
1. PREPARATION
• Remove all trays from inside the Kegerator body.
• Read your CO
2
Cylinder Safety Instructions that are provided with your cylinder.
• Sit ends of your tubing that are not connected to anything in a jug of warm water to
make the ends more malleable and easier to fit on to attachments.
• Remove any plastic protective layer from the stainless steel. Remove this layer
before first use as it can become hard to remove if the unit is operated with it on.
2. FITTING THE WHEELS
• If you would like to fit the wheels to your Kegerator, carefully lay the Kegerator
onto its side.
NOTE:
You may like to put down some cardboard first if assembling on a hard surface.
• Remove the 4 adjustable feet from the base of the Kegerator.
• Screw on the wheels using the screws from the bag of 16 screws.
The 2 locking swivel castors should be installed on the front of the Kegerator
for easy access.
• Position Kegerator back uprigh
t.
The Kegerator body should be left upright for at least 1 hour before turning it on.
This allows for the refrigerant gas to settle, in order to work properly.
3. FITTING THE RAILS TO THE TOP OF THE KEGERATOR
• Place the metal rail on top of the Kegerator so the curved sides face
upwards and the stud holes line up.
• Push the studs of the railing down firmly into the stud holes.
