surfer bather
MI0132 issue 6
8
10
1
2
A
D
E
B
F
C
A
5
freedom through lightweight solutions
9
To remove the Surfer Bather from the bath
Drain the bath water.
•
To aid removal from the bath, the platform should
•
be separated from the scissor lift. Partially elevate
the Surfer Bather and pull the locking catch levers
fully out (see fig.1) to unlock the platform from the
scissor lift. Unclip the platform from the scissor lift
(
1
fig.8). Swivel the platform as indicated (
2
fig.8) to
disengage the bars from the slots on the underside
of the platform.
NOTE:
The locking catches must be released before
attempting to separate the platform from the scissors.
Lift the rim on each of the two large suction cups
•
on the base board to release the suction between
suction cup and bath (
A
fig.9) and remove the
scissor assembly from the bath.
The four small suction cups on the base board
•
(
B
fig.9) will release their suction as the scissor
assembly is lifted from the bath.
NOTE:
Never attempt to remove the Surfer Bather from
the bath without first breaking the suction under each of
the two large base board suction cups or damage will
result.
Re-fitting the Netting to the Backrest Frame after
laundering
Insert the thigh support foam (
•
A
fig.10) in the netting
lower pocket.
Insert the backrest frame into the pocket of the
•
netting (
B
) and fasten the four buckles (
C
).
Tighten or slacken the buckle straps in order to
•
adjust the tension of the netting on the backrest
frame.
Insert the headrest foam (
•
D
) in the pocket of the
headrest netting and if required, Velcro® the
headrest to the backrest.
The chest strap (
•
E
) can be attached to the Velcro®
panel (
F
) as required.
