MANDÍK 0789-0010, Установка, наладка, обслуживание

Страница: 26 / 51

MANDÍK CPV Installation, commissioning, and maintenance
IZU 02/2021 MANDÍK, a.s., www.mandik.cz
R
26
•
Nominal parameters of the equipment (air output, fan motor current ratings –
nameplate values)
•
Measuring instruments in use
•
Functional schematic of the equipment, including a schematic of the ductwork with
dimensions and specification of components (inserted elements
– attenuators, filters,
etc., control dampers, tees, elbows, etc.)
•
A list and the values of measurement points
•
Schedule of the control process (start-up of the unit and shut-down of the unit)
•
Climactic conditions during operation of the unit (initial and final temperatures and
humidity of the supply and return air)
•
A record of operation and the status of individual parts of the unit specified in
subsection 7.1
•
A record of any identified defects
•
A record from evaluation testing (results, date, etc.
•
A table of measured and set values for the individual fans (air output, currents, etc.)
8.5 OPERATOR TRAINING AND HANDOVER OF THE UNIT
The following steps must be performed during training:
•
User training for operation and maintenance of the unit
•
Completion of a training record. A copy shall be sent by po st to MANDÍK, a.s. or via
email to the service department at service@mandik.cz
•
Training for operating and configuration of user parameters of the Climatix control
system controller
•
Completion of a control system training record. A copy shall be sent by post to MANDÍK,
a.s. or via email to the service department at service@mandik.cz
•
Completion of a record of unit configuration. A copy shall be sent by post to MANDÍK,
a.s. or via email to the service department at service@mandik.cz
•
Handover of the unit to the user
•
Completion of a record of handover of the unit to the user. A copy shall be sent by post
to MANDÍK, a.s. or via email to the service department at service@mandik.cz
•
Establishment of an operating log book for the equipment
•
Handover of documentation to the user (instructions from the manufacturer, technical
audit of the electrical installation, training protocol for operation and maintenance,