M&C GenTwo PMA1000V2.4, Инструкция по эксплуатации

Страница: 59 / 110

58
GenTwo® PMA1000 V2.4 | 1.00.00 www.mc-techgroup.com
Fig. 66: Adjust pressure gauges and flow sensor
This section shows the actual value and the set point of the pressure gauges and flow
sensor. By tapping on the set point values, the temperature, pressure or flow rate can be
adjusted. The actual values change to the new set points.
Note
To set P-IN and P-OUT values for the barometric pressure correction,
the gas connections must be disconnected, and the analyzer must
be free of any gas flow.
Note
Please be careful when changing these values. Make sure that you
enter the correct values. These values have a direct impact on the
measuring values and ranges.
For more information about the calibration of the analyzer, please go to page 65 chap-
ter 'Calibration' .
8.3.13 M6/S1 Help button
If you tap on the help button M6, a technical documentation opens.
With the zoom buttons at the bottom of the screen, you can display a whole page on the
screen and zoom in and out of the document.
To scroll through the technical document, please swipe vertically up and down.