Mamod SL1K, Руководство по сборке

Страница: 4 / 8

- 3
–
Take combustion chamber ( item 33 ) and insert between side tanks and secure to cab with 2
( item 6 ) screws and 2 ( item 26 ) nuts to bottom fixing tags.
Next slide boiler into combustion ensuring that the side tanks lugs nest into the slot between the
boiler and front casting and whistle lever locates into cab. Secure both side tanks to front end with
black pozi screws ( item 48 ).
Take reflector ( item 38 ) and locate into boiler end hole ( this rests on the inside lip of the end
hole ). Fit ‘O’ ring ( item 39 ) on inner rim which forms a gasket.
Place glass ( item 40 ) on top of ‘O’ ring, carefully fit gauge ( item 42 ) over glass, secure with 2
small screws ( item 6 ). It is essential that great care be taken over this operation to ensure a
steam tight seal. It is advisable to hold the gauge firmly in position with thumb and screw down
each screw a turn at a time.
Locate grab rails ( item 41 ) through tank side and cab secure with 4 nuts ( item 46 ).
Fit 2 short screws ( item 6 ) and 2 nuts ( item 26 ) to underside of cab.
Take ( item 45 ) roof clip secure into roof ( item 44 ) with 2 black screws ( item 27 ) and nuts
( item 26 ).
Ensure that roof clip tags face downward and toward rear of cab. Then fit roof to cab with 4 black
screws ( item 27 ) and nuts ( item 26 ).
FINAL ASSEMBLY
Take chassis and cab assembly and carefully feed cab assembly over steam and exhaust pipe
and at same time locating reversing lever in slot. This operation can be best done by holding cab
at approx. 45° to chassis and offering the cab over pipes and reversing lever.
Finally ensure correct location by pressing with both thumbs on underside of chassis by base of
reversing bloc, squarely fixing side frames to outside of casting tabs.
Fit 2 front screws ( item 6 ) to secure side frames to casting. This may prove a little difficult. It is
best to dip screwdriver into grease or Vaseline to ensure the screw adheres to screwdriver this will
enable location into screw holes by the side of the cylinder.
Fit buffer beam ( item 10 ) over coupling in drag-beam ( item 9 ) and fit to rear of side frames.
Take buffer ( item 25 ) and feed screwed end into buffer stock ( item 24 ) locate into buffer beam
and secure with nuts ( item 26 ). Fit coupling ring ( item 23 ) by prising open ( such as with key
ring ) and feed into bottom section.
Fit rear fixing screws ( item 6 ) and secure side frames to drag-beam. Fit 2 screws and nuts to
secure cab to each side frame.
/Continued on page 4