Mamod SL1K, Руководство по сборке

Страница: 2 / 8

LOCOMOTIVE ASSEMBLY INSTRUCTIONS
To ensure ease of construction reference to these instructions are essential.
All the major parts are in the front of the box and the small components are in polythene bags.
Numbers on the bags refer to items on the drawings.
When constructing for ‘Gauge 1’ ensure longer wheel assemblies are used, and fit 6 gaskets
either side of port face.
Stage 1
CHASSIS ASSEMBLY
Essential tools are small screwdriver and a pair of small electrical pliers. Desirable tools are 6BA
spanner or small adjustable spanner.
SUB ASSEMBLY
– CYLINDER AND PORT FACE RIGHT HAND
Take cylinder ( item 1 ) and place on port face ( item 2 ). Fit spring ( item 5 ) over trunnion bolt
( item 4 ). Locate bolt and spring through rear of port face and screw tight into cylinder.
Repeat for cylinder and port face left hand.
FRAME AND CYLINDER ASSEMBLY RIGHT HAND
Take 2 gaskets ( item 3 ) and fit to rear of cylinder and port face assembly. Place on frame
( item 7 ) locating bolt and spring through hole. Align screw holes and fix rear holes with 2 long
screws ( item 28 ) and nuts ( item 26 ).
Frame and cylinder assembly left hand repeat as above.
WHEEL AND MAIN FRAME ASSEMBLY
Take both frame and cylinder assemblies and place back to back. Take leading axle assembly
( item 54 ) ( long pins ) and slide axles into front slots ensuring brass bearings are outside the
frame.
Repeat with the trailing axle assembly (item 55) ( short pins ).
Pull frames apart, this will locate bearing bushes into location holes. Fit spacer ( item 8 ) with 2
short screws ( item 6 ).
REVERSING VALVE ASSEMBLY
Take ( item 12 ) reversing block and insert 2 ‘O’ rings ( item 13 ) to counter bored holes in rear. Fit
spring ( item 17 ) onto bolt ( item 18 ). Pass bolt through retainer plate ( item 14 ) and through rear
of block ( item 12 ) and screw into reversing lever ( item 11 ) ensuring alignment of holes in
retainer plate with rubber ‘O’ rings.
/Continued on page 2