EN
13
6) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is main
tained.
SPECIAL SAFETY INSTRUCTIONS
• Hold power tool by insulated gripping surfaces, when performing an operation where
the cutting accessory or fastener may contact hidden wiring. Cutting accessory and
fasteners contacting a “live” wire may make exposed metal parts of the power tool
“live” and could give the operator an electric shock.
• Use appropriate detectors to determine if utility lines are hidden in the work area or
call the local utility company for assistance. Contact with electric lines can lead to
fire and electric shock. Damaging a gas line can lead to explosion. Penetrating a
water line causes property damage or may cause an electric shock.
• Switch off the power tool immediately when the tool insert jams. Be prepared for
high reaction torque that can cause kickback.
The tool insert jams when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
• Hold the machine with a firm grip. High reaction torque can briefly occur while
driving in and loosening screws.
• Secure the workpiece. A workpiece clamped with clamping devices or in a vice is
held more secure than by hand.
• Keep your workplace clean. Blends of materials are particularly dangerous. Dust
from light alloys can burn or explode.
• Always wait until the machine has come to a complete stop before placing it down.
The tool insert can jam and lead to loss of control over the power tool.
• Do not open the battery. Danger of short circuiting. Protect the battery against heat,
e. g., also against continuous sun irradiation and fire. There is danger of explosion.
• In case of damage and improper use of the battery, vapours may be emitted.
Provide for fresh air and seek medical help in case of complaints. The vapours can
irritate the respiratory system.
• When the battery is defective, liquid can escape and come into contact with adjacent
components. Check any parts concerned. Clean such parts or replace them, if
required.
DESCRIPTION OF SYMBOLS
Pay attention to all the signs and symbols shown in these instructions and on your
tool. Make a note of these signs and symbols. If you interpret the signs and symbols
correctly, your work with the machine will be safer and better.
Important
Read the instructions for use before starting the machine
Wear safety goggles
Wear ear protection
