JACK - 4 CH UHF TRANSMITTER
Description:
The JACK TRANSMITTER is a UHF 100mW 4 channel transmitter that may be monitored by a base station up to
6 km away (depending on environment) .
- Existing alarm panel
- Electric Fence
- Panic buttons
- Fire detection system
CH 4
CH 3
CH 2
CH 1
Applications:
+
-
12V
CODE PROGRAMMING
The frequency is pre programmed in the factory
This can be done manually (see below) or using our standard universal programmer (supplied separately).
NOTE: A test signal is sent every 24 hours. This may be changed on request.
1- Apply power to the unit
2- Press and hold the button until the green and red
LED flash continuously
3- Using the and the buttons enter a 5 digit number
(NO HIGHER THAN 09999)
which will be the Transmitter Code (ID).
4- After the fifth digit is entered the onboard LEDs will flash
for one second.
5- Press the button TWICE to exit programming or
simply remove power.
. The ID code MUST be programmed by the user.
Programming is accomplished by using the
I (Inc)
and
S
(Step)
buttons.
Transmitter code:
LEDS
Inc
Inc
Step
Step
I
S
EXT
TST
A
B
RX
1 2 3 4
POWER
+
-
I
S
EXT
RX
- +
1 2 3 4
PWR
Yellow:
Channel 1
Green:
Channel 2
Blue:
Channel 3
White:
Channel 4
Red:
Positive 12v
Black:
Negative 0v
The Jack is supplied with six
colour coded wires. The
connections are as follows:
Power is constantly applied to the unit but each channel is triggered by applying a
positive 12v to the input.
N/A
Monitoring Software
Base Station
S
S
S
I I S
I I S
I
0
1
2
3
4
(Step)
(Inc)
Steps you to the next digit and Increments that digit
To program the Transmitter (ID) Code to 01234 (5 digits with leading zero)
Hold the
I
button until the green and red LED flash continuously.
Now using and
S
enter 5 Digits (01234) =
I
Example:
I
I
I
I
I
M000050
2
