Eye Protection
The use of safety goggles is mandatory requirement (normal glasses are not sufficient for
eye protection).
Ear Protection
Ear protection is advised during periods of extended operation.
Footwear
Where there is a risk of a heavy object damaging feet or there is a risk of slipping on wet
or slippery floors suitable non-slip safety footwear should be worn.
Head Protection
Where there is a risk of falling objects or hitting your head on protruding or low level
obstructions a hard hat should be worn.
Do Not Abuse the Power Cord
Never yank or pull on the power cord to disconnect it from the mains supply socket. Never
carry your power tool by its power cord. Keep the power cord away from heat, oil, solvents
and sharp edges. If the power cord becomes damaged have it replaced by an authorized
service facility.
Do Not Over-reach
Do not over-reach, keep proper footing and maintain your balance at all times.
Maintain Tools with Care
Follow the instructions for lubricating and changing accessories.
Check the tool power cord periodically and if damaged have it replaced by an authorized
service facility.
Inspect extension cords periodically and if damaged replace it.
Keep handles dry, clean and free from oil and grease.
Ensure that ventilation slots are kept clean and free from dust at all times. Blocked
ventilation slots can cause overheating and damage to the motor.
Disconnect Power Tools
Ensure that power tools are disconnected from the mains supply when not in use, before
servicing, lubricating or making adjustments and when changing accessories such as
blades, bits and cutters.
Remove Adjusting Keys and Wrenches
Avoid Unintentional Starting
Ensure that the switch is in the OFF position before plugging the power tool into the mains
supply.
Extension Cords and Reels
The device should only be connected to a network that is protected by a residual current
device (RCD) with a tripping current not exceeding 30 mA for mains-powered machine.
The appliance should be supplied via a residual current device (RCD) with a tripping
current of not more than 30 mA.
When the power tool is to be used outdoors, use only extension cords intended for outdoor
use and are so marked.
Always unwind any extension cords fully.
For extension cords up to 15 meters use a wire cross section of 2.5mm
2
.
19/39
