Malsch bakare IMPULSE, Инструкция по эксплуатации

Страница: 44 / 62

44 |
Integrated bed extension
Beds equipped at the factory with an integrated bed extension
(optional) can be extended by up to 20 cm without tools. For
this to be possible, the side rail bars of full-length side rails must
be replaced.
This function is activated in three stages and without tools using
the two locking bolts at the bottom foot end of the sleeping
surface:
1. On the IMPULSE care beds with undercarriage Editions
400 / 400 LR, pull both locking bolts upwards and then
rotate them about a quarter turn to the right until they
reach the locking point. On the IMPULSE care beds with
undercarriage Editions 420 / 420 LR, the locking bolts point
laterally inwards. The mode of operation is analogous to
the chassis editions described above. The bed extension is
now unlocked.
2. Reach below the foot board and carefully pull out the bed
extension by approx. 10 cm or 20 cm.
3. Finally, turn the locking bolts back to their original positions.
Afterwards, push the bed extension back carefully until the
mechanism engages.
Caution! A mattress insert (accessory) must be
used with 20 cm extensions. To use a mattress in-
sert, fi rst pull the bed extension out as far as it will
go. Once the insert has been positioned, continue
as described in point 3.
Caution! The sleeping surface extension must only
be activated by authorised specialist staff .
1.
2.
3.
Locking bolts
IMPULSE care bed with undercarriage Editions 400 / 400 LR and Edition XL